|05-30-2011, 01:20 PM||#1|
Join Date: Jun 2008
Location: S.E. Michigan
Turtle Racing V1 Pull Start Not Engaging?
We have found an issue with the Alum pull start pawl that can affect engagement. This also applies to using the Alum Pawl in stock Pull starts.
You will need to do this ONLY if your pawl is not engaging, if your pawl is engaging there is no need to do this.
It is a very simple fix and I even did it with my wifes Nail File to show how easy it is.
1st-Remove Screw inside housing
2nd- remove washers, spring and pawl
3rd-Locate nubs on the pawl
4th-Gently file the tops of the nubs, take off a little and test
5th-Reassemble, make sure that the square on washer lines up with stud, install screw.
Install and Test the starter on the motor, if the pawl doesn't engage, repeat proceedure.
|Turtle Racing V1 Pull Start Not Engaging? - Similar Threads|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Turtle Racing V1 Pull Start Recall||TurtleRacing||Turtle Racing||11||04-23-2013 07:43 AM|
|New Release Turtle Racing Version 2 Pull Start||TurtleRacing||Turtle Racing||116||10-11-2012 11:13 AM|
|Turtle Racing Pull Start V2 Install video.||FastEddy||General Large Scale||4||03-06-2012 10:43 PM|
|Turtle Racing Pull Start Giveaway!||badger||General Large Scale||24||06-14-2011 06:18 AM|
|New Turtle Racing Pull Start||TurtleRacing||Turtle Racing||5||06-05-2011 01:11 AM|