|
Home | Forums | Register | Vendors | Garage | Forum Rules | FAQ | Classifieds | Calendar | Mark Forums Read | Track Locator |
![]() |
| LinkBack | Thread Tools | Search this Thread | Display Modes |
Monster truck | ||||||||||||||||||||||||
| ||||||||||||||||||||||||
Comments: 87 /
Views: 25311
|
![]() | #41 |
Addict | ![]() Bought a huge box of wheel this week. I just finished going threw them. Total 23 tires 12 aluminum rims sets and 12 plastic rims sets. Half 4 pin other 6 pin. I think I will sell the 4 pin wheels As I mainly use 6 pin. |
![]() | ![]() |
Sponsored Links | |
![]() | #49 |
Addict | ![]() Plastic rim arrived today. Most are 4 pin. A few that were 6 pin and 4 pin same style as I had purchased before and other 4 pin area different style rim. I have cleaned 1/2 of the box. total were 21 complete rims. 2 rims halves are a different width. Not standard 1" or 2 " like 1-1/2" and another 2 wheels were one piece. |
![]() | ![]() |
![]() | #51 |
Addict | ![]() Working on the off road truck. Moved rear swing arm suspension mount 1" back. Moved motor mount 1" back . Installed shorter rear shocks. machined 1.5" off rear swing arm. Moved rear upper suspension mount 3/8" down. |
![]() | ![]() |
![]() | #55 |
Addict | ![]() Went threw the lot today and there were lots of new part Enough to build 2 + engines and I have a third from another lot that now can be completed. All that was missing was hardware to complete the second and third engines. |
![]() | ![]() |
![]() | #60 |
Addict | ![]() cut carbo fiber sheet today. I didn't have a carbide tip blade. So I had to do some edge sanding to get throttle servo plates to size. I made 6 . Drilling wasn't a big deal. I use a end mill for the 1/2" bore holes. I will finish the other 3 tomorrow I mounted one and tried it out. Much stiffer now.. Last edited by king quarterscale; 09-12-2020 at 01:46 PM. |
![]() | ![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
| |